Make an LED Blink Using a Breadboard

Linkbot Image Mindstorm Image Cursor Image
0x2418126-6-12y2418126-6-12
Grid:
Tics Lines:
Width px
Hash Lines:
Width px
Labels:
Font px
Trace Lines:
Robot 1:
Width px
Robot 2:
Width px
Robot 3:
Width px
Robot 4:
Width px
Axes: x-axis y-axis Show Grid
Grid: 24x24 inches 36x36 inches 72x72 inches
96x96 inches 192x192 inches
Quad: 4 quadrants 1 quadrant Hardware
Units: US Customary Metric
Background: Background Image

Robot 1

Linkbot
Mindstorm
Initial Position:
( in, in)
Initial Angle:
deg
Current Position: (0 in, 0 in)
Current Angle: 90 deg
Wheel Radius:
Track Width:
in

Robot 2

Linkbot
Mindstorm
Initial Position:
( in, in)
Initial Angle:
deg
Current Position: (6 in, 0 in)
Current Angle: 90 deg
Wheel Radius:
Track Width:
in

Robot 3

Linkbot
Mindstorm
Initial Position:
( in, in)
Initial Angle:
deg
Current Position: (12 in, 0 in)
Current Angle: 90 deg
Wheel Radius:
Track Width:
in

Robot 4

Linkbot
Mindstorm
Initial Position:
( in, in)
Initial Angle:
deg
Current Position: (18 in, 0 in)
Current Angle: 90 deg
Wheel Radius:
Track Width:
in

Make an LED Blink Using a Breadboard
Problem Statement:

For this activity, you will use the Arduino to make a red LED blink. Connect the LED module to pin 3 on the Arduino using the breadboard, as shown in the picture displayed in the lesson description above, and use the "Run" button to run the code blocks provided to turn on the red LED for one second and then turn it off, for three times total. Once it is working, can you make a change to increase the time that the LED is on?

/* Code generated by RoboBlockly v2.0 */
#include <arduino.h>

pinMode(3, OUTPUT);
digitalWrite(3, HIGH);
delay(1000);
digitalWrite(3, LOW);
delay(1000);
digitalWrite(3, HIGH);
delay(1000);
digitalWrite(3, LOW);
delay(1000);
digitalWrite(3, HIGH);
delay(1000);
digitalWrite(3, LOW);
Blocks Save Blocks Load Blocks Show Ch Save Ch Workspace
Problem Statement:

For this activity, you will use the Arduino to make a red LED blink. Connect the LED module to pin 3 on the Arduino using the breadboard, as shown in the picture displayed in the lesson description above, and use the "Run" button to run the code blocks provided to turn on the red LED for one second and then turn it off, for three times total. Once it is working, can you make a change to increase the time that the LED is on?


		
Rubbish bin
Time